Periodic Controls

Periodic tests and controls are routine operations that must be performed by technical personnel, such as machine engineers / technicians, that must be performed at every workplace where machinery or work equipment is used. It is possible to extend the service life of the equipment and to prevent possible accidents, such as the servicing of the same car as the periodic inspection of the machine equipment.

PERIODIC TEST AND CONTROLLES LEGAL PLACE
Article 10 of the Occupational Health and Safety Act holds the employer responsible for all risks incurred in the workplace. This is the duty of the employer to control the reliability of machine and work equipment, which are potential sources of danger.

Article 7 of the Health and Safety Conditions Regulation for the Use of Work Equipment, dated April 25, 2013 specifies that the machine and work equipment at work shall be tested and checked at regular intervals to the authorized body and persons and the audit reports shall be archived. Audit reports carry a responsibility to the person performing the audit so that the person who has signed the audit and has the right to use it for the audit report deserves the job. Otherwise, the person who takes control at an accident that will occur later will be among the responsible ones.

All machinery and equipment used in the business environment must be checked by a mechanical engineer at intervals determined by the law. This is a more detailed check by the independent organization of the intention of the producer company to control during the routine checks. There is no obligation of the producer company's controls against the laws, and the actual responsibility is the company that performs the periodic check.

LIFTING - PERIODIC CONTROL OF TRANSMISSION VEHICLES
The obligation to perform periodic checks identifies the Health and Safety Conditions Regulations for the Use of Work Equipment. Accordingly, periodic controls of the lifting and conveying devices used must be made by authorized personnel of a laboratory with Type A inspection institution accreditation.

lifts
caraskal
Vehicle Lifting Lift
Mobile Crane
Crane
forklifts
Transportable
The tower crane
Platform
PERIODIC CONTROL OF PRESSURE CONTAINERS
The obligation to periodically check pressure vessels and equipment has also been specified by the Health and Safety Conditions Regulation for the Use of Work Equipment, as it is found in lifting and conveying equipment.

Hydrofoil Tank
Boiler Room
Heating boiler
Steam boiler
Expansion Tanks
Air tank
Autoclave
Hot Oil Accident
PERIODIC CONTROL OF ELECTRICITY AND EARTHQUAKE
All electrical and grounding systems must be periodically tested and inspected by an electrical engineer on a regular basis.

Lighting System
Electrical Installation
Grounding System
Board and Operation Earth
Explosive Ambient Electrical Installation
Lightning Rod Installation
Strong Current Installation

Other Services

Workplace Physician

Hekim Oğul OSGB infrastructure is a doctor who has never had a workplace

Read More

Job security specialist

Occupational Safety Specialist, graduated from engineering or science faculty of universities...

Read More

Workplace Nursery

It is limited that the health staff can legally do the workplace nurse

Read More

Media Measurements

The ambient dust, noise, lighting and gas level are determined by the isg environment measurements.

Read More

Periodic Controls

Work machines should be regularly checked by a mechanical engineer.

Read More

Electrical and Grounding Controls

Electrical systems should be periodically checked at regular intervals.

Read More